2000 Dodge Intrepid "cam sensor" Questions

...signal at pcm, has 5 volt supply at cam sensor and ground at cam sensor. I thought it would start with the cam sensor unplugged, it would just have a long crank time. crankshaft sensor had same ...

cam sensor unplugged because the ecm sees the camshafts aren't in time with the crankshaft. With the cam sensor unplugged it doesn't know its out of time and it starts.' Does it means that

...cam sensor it runs?what that mean is that most likely your sensor is bad..reason for that is when your cam sensor is out you unplug it...it will run because it forces the computer to get a ...

...cover. I just unbolt the upper intake just enough to lift it up a little. unbolt the cam sensor, pull it out and install the new one keeping pressure on it until it's bolted in. I hope this ...

...cam sensor plugged in. new sensor first symptom sounds like mass air flow sensor,cam angle sensor may be moving the timing out of startble range,,check timing belt for condition and verify timing ...

...cam sensor , But the the CAM sensor should fix this.. But check and be sure wiring to sensor is ok. God-Bless! test crank and cam sensor and check plugs for dirt or corrosion. When these have ...

...cam sensor or crank sensor, the best thing to do would probably be to get it analyzed with an obd2 testor, that would pinpoint the problem to the correct sensor.... if that is not an option for you i ...

cam shaft sensor fault. Because the engine is starting then stalling, check to see if you have spark after the stall. If spark is still present, you are probobley looking at a cam sensor circuit issue

it had one.the cam and crank sensor will not affect fuel pressure. the cam sensor should not stop this car from starting. but the crank sensor will. good luck. check coil pack/module connector as well

...ignition switch, starter, cam sensor, or crank sensor? could be either the cam sensor or crank sensor , but I would check the crank sensor first , this sensor will not cause a check engine light ...