1988 Chevrolet S-10 "joints trans slip" Questions

...slip yoke. Then you need to move the front of the shaft in by the trans and as far forward as you can. it will be right along side the yoke you unbolted it from and the u joint has to be turned just ...

...trans or you'll be swimming in oil.If you like to mark your yoke for orientation do it now.There's 2 kinds of u-joints,one uses snap rings, the other is injected with plastic around the cups.You'll ...

...trans is bad it slips a little at first.. had fuel rail sensor code previously? any thoughts? There could be many reasons relating to this problem. But inspect the cv joints at the transmission side. ...

...trans to rear wheels, put new u-joints in it but it looks like its the cv in the trans end. will not rotate or (slip yoke), is it a cv joint or is it supposed to remain stationary. you can move the ...

..."U" Joints? U-joints would be one thing I would inspect. Check drive-shaft slip yoke for play, ring and pinion for slop, Also trans mount, engine mounts and rear leaf spring and shackle

...joints need replacing. Is this possible even though I clearly see the torn boot and the trans was slipping a little hi there, yes it is possible that the ball joint could be making that noise,a cv ...

...trans. Check your drive line, a universal joint thats going out can make a sorta ringing, pinging sound. Also check the collar there at the slip joint, if it has come unscrewed it to could make a ...

popping rattling noise in front slipping and leaking tranny Rebuild the transaxle & check the CV Axle Joints for problems, as well as replace all motor & trans mounts

...in other SUV's. Is it common? could be your drive shaft slip yoke needs to be cleaned & lubed. It binds on take off instead of sliding on the trans output haft. Other possibility is

...joints both half shafts up front only thing i can thing of next is the trans fer case or is there something else that could be causing it Banging noise can be caused by broken hand brake shoes inside ...