...replace the power steering pump, proceed as follows: 1. Disconnect the power steering return hose from the remote reservoir or pump. Allow the fluid to drain from this hose into a drain pan. Discard ...
...from underneath ?? you have to remove your power steering pump to replace your water pump you remove one bolt from the top and one from underneth by going threw holes in power steering pump ...
...replace the power steering pump on 1996 oldsmobile delta 88 remove the pressure and return line, the belt, remove the mounting bolts. Use a "power steering pulley puller" to remove the puller. This ...
Question about Chevrolet Corsica
replace the water pump? There is a bolt from the water pump that hits the pulley on the oil pump. It is a 1995 Olds Delta 88 with a 3800 engine. How can this be resolved? Thanks! If you mean the power
Question about Chevrolet Corsica
...replace the power steering pump and replace the serpentine belt? The fluid appears to be leaking under the pump, but the pump seems to be free. The idler pulley also seems Ok so we are assuming it is ...
power steering belt needs to be replaced and tightened, how do i do it? The belt is changed by loosening the power steering pump at the adjustment bolt and also the pivot bolt:The following ...
...power steering pump water pump all belts and one pulley and it still squeals its an 88 cadillac brougham de elegance Check crank damper/pulley for misalignment. Gets oil on it, or the rubber just ...
Question about Chevrolet Corsica
...power steering pump to replace the water pump I have the 3800 series 2 V6 engine the pulley needs to be removed to remove the PS pump, this pulley is pressed onto a tapered shaft (they used a bolt ...
Question about Chevrolet Corsica
...power steering pump to replace water pump On a 1996 Olds Ciera, How do your remove the powersteering Pump?? i use a 1/4" drive 10mm long socket and insert it through the openings on the pulley and ...
where is the power steering pump located and how hard is it to replace, I'm a girl! Special tools are needed to replace the pulley. I would have a shop do it for you. Are you sure its bad?
96 questions posted
Usually answered in minutes!
204 Questions
184 Questions
199 Questions
173 Questions
159 Questions