Question about Chevrolet S 10
...the map sensor located on 1985 s10 pickup 2.8 liter v6 looking for map sensor on 1985 s10 2.8 v6 it has one vacuum line to it and its half the size of a pack of cigarettes. Look around the intake ...
S10 Map Sensor. It has grey,purple,and green wires. Just need to know which wire goes to what. one wire gos signal,5 volt, other gos 12 volt. other to ground need a wire diagram to determine which one
s10 blazer 4.3 the prob started the other day drove for couple hours then just hesitated real bad at steady acceleration.if floored would take off fine,today filled up tank and drove bout 4 blocks and
...S10 2.5L 4 Cylindar very sluggish to accelerate very sluggish to accelerate and seems to get stuck around 30-35 mph. it winds out in gear. fuel injector was leaking, repplaced that. no help. it seems ...
...S10 2.2l Replace MAP sensor and main vacuum line, but after driving for about an hour it bogs down after accelleration from a stopped position. After that it runs great, only does it when stopped. ...
...s10 zr2 with a 4.3l now I replace the fuel regulator and fuel pump amongst a bunch of other sensor like the crank sensor and the map sensor now its backfiring out of the intake and now when u let the ...
...s10 idled crappy and shook around like an earthquake when i started it, but to start it i had to hold the gas down to the floor to do so, and it started fine the 15 minutes before, what could cause ...
pulling code 34 chevy s10 92 very rough idle I think 34 is MAP sensor code make sure you have vacuum to sensor
i got a 92 s10 that wont run did cap and roter plugs timing belt map sensor and camp . i got gas and fire What about the crank sensor?
...s10 4.3 which starts nd runs fine until given gas it falls on its face bogs down then will take off any ideas i have replaced dist,fuel pump,tps,map sensor ,coolant temp sensor,egr,wires cap & ...
460 questions posted
Usually answered in minutes!
1,473 Questions
904 Questions
790 Questions
747 Questions
686 Questions