1985 Chevrolet C2500 "run 2" Questions

...2) encrusted valve stem 3) clogged exhaust gas feed pipe. A quick check for function: run the engine and remove the vacuum tube. The engine note should change as the tube is connected and then ...

Hard starting and stops running after it gets hot What s making it hard to start/Battery down/Slow turning over /lack of fuel.etc etc?? How hot does it get /how many miles before if stops running/How ...

...ignition system but still has problem could be one of several things 1) run a compression check, if it low on that cyl then you have a blown head gasket or burnt valve 2) could be the ...

...2-bbl on the v8 motor {350). Have gas coming into throddle body, but injectors not allowing gas to flow. Test spark from coil to distributor and #1 plug to plug wire. Also, checked ignition coil. All ...

my truck stumbles with a 2 bbl carburator chevy the truck runs and it turns on at the first start but when ur driving or over streer the truck turns off and on the highway u cant speed up past 50mhp ...

hey guys .i have a 1990 chevy c2500. a while back it started running kinda rough when at low rpms... then it began blowing the ecm fuse after running for about 10 minutes, and the check engine light ...

...fuel into the TBI and the engine will not start will start if fuel is poured direct into carb and runs until depleted have also replaced the manifold actual pressure sensor still to no avail can

...run from the resavoir to the rear axel in one piece. Is it one piece? Thanks. I don't know if it's one piece (it probably is), but if the line is rusted through, you should replace the entire line ...

i have a GMC 2300w AVR generator which is pull start. it starts, runs for a min or two then cuts out..have clean fuel filter, air filter, spark plug, what else could it be...it still cuts out without ...

1985 chev p/u 5.7l will not stay running replaced fuel pump. got fuel/got spark/all good.runs 2 sec. Its carb right if all ealse fails ck there