1983 Chevrolet K1500 "oil coming vent valve pressure" Questions

oil cap is vented. your engine is building up pressure and has no where to vent,so it blows the easiest thing,the dip stick Your dip stick might be hittin the crank(put the stick in with the motor on

...oil from coming from my dipstick? they say it's blowback. Depends on the cause. Blow-by is when oil blows by the rings in the cylinders into the combustion chambers or compression blows by the rings ...

coming from the exhaust and got oil on the spark plugs, i changed the plugs and within a few miles the plugs were soaked again, whihc makes the car judder all the way up the revs and smell really hot,

...maybe the injectors check your fuel pump pressure, around 65 to 80 psi at idle ,if it seem good clean your idle air control valve.the IAC valve normally gets fouled up with oil,sludge from the oil ...

coming out if u open the filler cap it will be gone is there a pcv valve in this car model or the oil trap box The noise is from crankcase being under vacuum and the air being sucked through cam seals

oil leak and have not been able to locate the source. It is not the head gasket that was just replaced, any ideas. if it is coming from up top it is in all probability the valve cover-check to be sure

...vent circuit low= p0446 1) Make sure the gas cap is ON (and "clicks" ) and is the correct Toyota Gas Cap (aftermarket may not work). Clear the codes and run for a while. See if codes come back. 2) ...

...Oil changes, air & pollen filters, tire rotation & wheel balances rule 1, P2 means private Toyota code DCT. where did you see this. on the dash, at autozoned. or where? where, counts. 2420 means EVAP ...

...vent "can" on v8 engines) on the valve cover though. If that is obstructed excessive pressure will build up inside the engine that can and will drive oil past even a good seal. Also check the oil ...

...oil dipstick I get some white smoke coming out from there.what can that be already changed the oil pressure switch and PVC valve when you drive the pressure should increase as the rpm goes up not ...