1991 Buick Park Avenue "coolant spraying throttle body" Questions

...coolant light is on... Disconnect the air intake to the throttle body and spray some Ether into the throttle body and see if it will attempt to fire. If it doesn't, you might want to get a spark plug ...

...coolant sensor the blaz, won't idle, when ac. is on, down rd. with ac. on, ok, but tac up & down, stop & motor dies, won't idle with ac, or blower motor on. Hello: Remove the ducting ...

...throttle body while cranking.see if you see fuel spray.if not, low fuel pressure of pluged fuel filter. also coolant temp or tps sensor could be at fault.have vehicle sensors scan tested for

coolant. Also check to see if there are any vacuum lines disconnected. They can also cause the high idle. Try cleaning your sensors, located on the throttle body with spray cleaner, especially made to

throttle is the cause of your car cutting out, check the ht leads and spark plugs, start the engine and spray some water over the leads and see if they ark then there is your fault. Is there an engine

...coolant sensor regularly on these cars, and the thermostat if the temp gauge is less than 1/4. I have one of these with 178,000 miles, they are great are but need some routine maintenance and a clean ...

...coolant hose it was small and located near the throttle body under where the position sensor plugs in. could coolant have contaminated my at fluid? More than likely your sensor got contaminated ...

...throttle down all the way to clear flood it to get it to start again. check for vacuum leaks. check your antifreeze and make sure it is full too since low coolant can cause the temperature sensor for ...

...throttle plate for the surging. make sure the belt your checking drives the water pump. there may be more than one belt and the water pump belt may be missing. oil in the coolant isnt good. thats a ...

...coolant.... You may have a bad IAC ( idle air control) but try cleaning the throttle body first. Remove the intake snorkel, have someone hold the throttle wide open for you and scrub the back side of ...