Question about Buick Park Avenue
1990 Buick Park Avenue. Code 41 and 42. 3800 VIN C engine. I have replaced the spark plugs, cam shaft sensor, throttle position sensor, coil pack. I took the wire harness out that goes to the ICM to ...
I own a Buick Park Avenue 1990 3.8L Heater I own a Buick Park Avenue 1990 3.8L the heater seems to be working but the air don't blow. Also the car will start sometimes with a key starter is fine but ...
i have no air flow in my mid vents 1990 dodge dynasty top and bottom vents work but no air flow from the middle vents Check your air flow controller. Bet the damper motor isn't getting any air
Anyone know if a 3.8 built in 1990 would fit into a 97 buick park ave it may fit ,but the 3.8 changed in 95-96 - heads /intake different - throttle cable connections should be different - main thing ...
Trying to remove the pulley on a 1990 Buick Park Ave. Which pulley, idler, tensioner?
Where is the starter located on a 1990 Buick park avenue bottom rear of the engine block at the tranmission bell housing
bypass pulley for 1990 buick park avenue power steering. I am using the engine for a speacial aplication and do not need the power steering pump why not just remove the pump and get a shorter belt ...
1990 buick skylark Mine does the same thing. Sometimes it starts right back up and sometimes it takes a half hour to start. Its very temperamental. It runs great and then it just chokes out. Whats ...
Question about Buick Park Avenue
1990 buick park avenve air mass flow sensor and crank sensor been replace car still starts buafter i drive it it cuts off but starts back after 20 min. Ignition control module could be the problem , ...
The speedometer stopped working on my 1990 Buick Park Ave. It's not digital, but I don't see a cable going to the transmission. Any idea where I should start? Do I take the dash apart? The needle will
848 questions posted
Usually answered in minutes!
585 Questions
537 Questions
482 Questions
474 Questions
426 Questions