1989 Chevrolet K1500 "replace" Questions

Door handle replacement for 1997 Chevy pickup I need to replace the driver side door handle on a 1997 K1500 pickup. Do you have any information on that? Thanks, Don Are you looking for a replacement ...

2000 chevrolet silverado shows bad oxygen sensor replaced still misses bad shows bad oxygen sensor replaced with new one engine still misses SOUNDS LIE YOU NEED TO REPLACE THE SPARK PLUGS AND IGNITION

replaced all bulbs in the tail light assemble, still no turn signal or brake lights coming on. Repalced the fuse, still nothing. try replacing the turn signal switch flasher and check to se if brake ...

wipers keep running after switch is turned off I have had this problem before which took a switch replacement. Does anyone know how to replace the switch? I forget how to replace it. There should be a

I have 110,000 miles and want maintenance advice. Vehicle runs well. Will do fluid replacements... Should I replace belts, etc... (assuming that I don't know the maintenance history of the vehicle)? ...

how do i replace the rear pinion seal on a 89 gmc sierra k 1500 WEll, essentially you remove the yoke and replace the seal. The issue, however, is that there is a ONE TIME USE crush sleeve that needs ...

intake manifold gasget replacement on 1994 chevrolet silverodo 5.7 engine. engine temp gets up to 210 degrees,goes back down to 195,thought t-stat sticking.checked,but saw anti-freeze coming out and ...

...in 2nd gear If this is a manual (5 speed) - you may have a broken shift fork. You'll want to either replace just the shift fork, or (best) - purchase a clutch kit for the truck as well as the shift ...

running bad replaced o2 sencers,fuel pump loud whine 58psi.misfirng no power Aaron, you said you replaced the fuel pump, did you replace the regulator at the same time, if not I bet this is your ...

passenger side brake light does not work at all-turn and back up lights dont work as well. replaced bulbs and still does not work. try to replace the board the bulbs plug into or replace the plug ...