1989 Chevrolet C1500 "engine timing" Questions

...engine with a timing lilght what are the steps to time a 1994 chev truck with a 350 engine with a timing light? engine idle and then check strobe light to mark on crank ,then slowly rev engine to ...

...way to check engine timing and what should it be set at. what should I change next? try timing i set mine at 4 degrees btc,dont forget to unhook your distributor bypass located behind your ...

...engine at base timing .. use timing light to see timing and turn the distributor after its loostened if nescessary to adjust it then retughten and turn off engine then reconnect the spout connector ...

...timing or a clattering noise coming from the front of the engine. It is a good idea to replace the water pump (coolant pump), and the thermostat while replacing the timing chain. The cost of the ...

timing the engine was loose. I repared the connection and the idle improved and the light went off. After driving the truck 5 miles or so approching a stop light in 5th gear under no accelerration the

...engine to get to the timing cover. Loosen the oil pan bolts to allow the timing cover to be slipped out. unbolt and remove the timing cover. Turn the engine over by hand until the dot on the ...

engine the timing will advance for second or two and then returns to static. This happens when I rev up and stay at steady rpm. I have tried disconnecting the knock sensor but all this does is put the

block? and what is the firing order on the same motor? 1-8-4-3-6-5-7-2 The timing depends on which horspower engine you have. The 502 hp engine is 12 degrees, I don't know about any of the other 502's

...engine until the timing marks on both sprockets are nearest each other and in line between the shaft centers. Here's a diagram -- often these are as good as pictures -- The "A" points to the 2 timing ...

...engine over again until the timing marks align and the rotor should be pointing towards the firewall as described above. Find the closest terminal in the distributor cap that matches the rotor's ...