1988 Chevrolet Suburban "remove distributor manifold" Questions

...REMOVE DISTRIBUTOR,MARK THE POSITION OF #1 DISTRIBUTOR CAP TOWER TO DISTRIBUTOR..REMOVE CAP AND TURN ENGINE TO LINE UP ROTOR BUTTON WITH THIS MARK..MARK DISTRIBUTOR HOUSING IN RELATION TO HOLD DOWN ...

remove the distributor. mark carfully the relationship of the rotor and the base to the engine block or other near reference marks/items. If it is not correct when you are done you will need a scanner

...distributor cap. Remove holder ring for spark plug wires then remove protective cover 2 screws 7mm then remove the four screws that hold coil in place. there are three wires 1 red and 1 white these ...

...Remove the distributor cap and reposition it out of the way. Remove the PCV valve. Remove the wiring support bracket at the rear of the manifold. Remove the canister purge valve. Remove the studs ...

...remove distributor cap and make sure the rotor button is set to fire on the # 1 position, replace cap this should get u running but you u still need to adjust with a timing light, but if ur familuer ...

distributor back out and look down the hole with a flashlight, you should see the top of the shaft, it looks like the head of a regular flat tip screw, if you do not see this the shaft is out of place

...manifold had repairs recently done. new starter put in also at same time. Now when I use my turn signals the car will die. also when in drive and the car idles the rpms drop too low and it sputters ...

...manifold off yet. I have one bolt left to take out and then the distributor. I just want to make sure I can get it back together properly and running..Any help would be great. Thanks for reading ...

...distributor cap and rotor, air filter, transmission filter kit, oil filter, and 5 quarts of oil plus transmission fluid. and oxygen sensor. Run some fuel injection cleaner in the gas tank. Remove the ...

...remove distributor from engine.INSTALLATION Install rotor on shaft. Position distributor in engine and ensure O-ring is properly seated on distributor. Replace O-ring if it is cracked or nicked. ...