1988 Chevrolet C1500 "replace push pull throttle cables" Questions

...pull the link out of the transmission and fit the cable end to the link as shown in Figure 1. Push the TV Cable sheath into the seal in the transmission and tighten the 10mm retaining bolt. If your ...

replace the throttle cable on a 1991 Ford E250 Club wagon van with a 7.3 Diesel engine It is on the gas pedal rod and goes through the floor to the throttle body pull the engine cover and then look at

...replace yourself. You will have to get the new one from the dealer or a scrap yard. It would be held on by a few push on clips and or small bolts/ screws. Start by unhooking it from the pedal and ...

...2 the cable itself, make sure it is routed simply, no loops or knots. once the cable is disconnected pull and push and feel. is it stuck? does it move freely? if its hard in any way, replace

properly. If this is a GM product,you will need to push in the silver looking button on the cable where it hooks to the throttle linkage,and pull the black plastic piece out (towards front) just a bit

...push it to the floor with no problem, it feels like there is something under the pedal that is keeping it fron going to the floor. i have checked all the cables cleaned the throttle body replaced the ...

...replace if necessary. The jerking when shifting is probably due to incorrectly adjusted kick down cable, when adjusted correctly the transmission with shift smooth. Hope this helps, let me know i ...

...push the coast , reset , and set nothing happen's. There are two main components of the cruise control system: the controller and the servo. The controller integrates all the inputs and tells the ...

push and pull the inner cable. It should move both directions freely without any hang-ups. Replace it if there are any problems. Don't try to oil it as it has a plastic liner inside the outer housing.

...replace it. you will see it on the intake manifold also pull off the air cleaner or hose and get a can of berry mans carb cleaner and clean the throttle plate inside and out then lube the throttle ...