1988 Chevrolet C1500 "front wheels 4x4 angle" Questions

...front axle nuts but which nuts ??the half shaft is held in by a horseshoe clip inside the diff unit,you must remove the diff cover,then remove a bolt that holds the planet wheels in place.remove ...

...front wheels clunk badly. I lifted vehicle clear of ground. Under low load (800-1000 rpm) just the rear wheels spin when in drive. When rpm is brought up to 1000-1200 transfer case will engage front ...

front wheels angle in towards the engine like there was a whale sitting inside. the front wheels on my 1999 ford ranger 4x4 supercab sit at an angle when in park. They slope in towards the engine like

replace bolt in shock.[ help ] If you have the jack in the correct location have you attempted to turn the front wheels to slightly adjust the angle of the hub relative to the shock and stabilizer bar

be a loose hub bearing causing the hub to move in and out .When accelerating the weight shift will be less on the front wheels so the hub may be moving in and out during this .Have this checked soon :

front-end/driveline shake and noises.  One has to do with the companion flange angle on your drive shafts and the other has to do with contact being made with the jounce bumper on the fron axles

Front Disc 1996 F-150, F-250, F-350 4x2, 4x4, Bronco and F-Super Duty Vehicles Workshop Manual REMOVAL AND INSTALLATION Caliper Heavy-Duty Rail Slider, F-Super Duty Replace brake shoe and lining (2001

...front and back wheels are aligned for proper tracking. Now after all that, in my case, I still have DW. But it now only happensonce and awhile at about 44 mph and quickly leaves by slowing downor ...

...4x4 and place the wood against the front edge of the brake drum hit it good and hard then move to the other side and do the same a few good sacks should loosen it up you will notice the drum start to ...

...4X4 INTERMITTENTLY SHUDDERS WHEN TURNING FROM A DEAD STOP. 150K MILES. DOES NOT DO IT WHEN GOING STRAIGHT. Front brake's either slow to retract, worn or loose. Its a front brake problem so better to ...