1986 Chevrolet S-10 Blazer "car stalling low speed chevy" Questions

...stalling issue at low speeds This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner from NAPA or Carquest (made by CRC ...

...low • DTC P0103 Frequency high The crankshaft position sensor provides the VCM with the crankshaft speed and the crankshaft position. The VCM utilizes this information in order to determine if an ...

...low idle air control (IAC) counts. • Check the IAC operation. Refer to Idle Air Control (IAC) System Diagnosis . • Check the control module grounds for being clean, tight, and in their proper ...

stalling on a 2002 chevy tahoe z71 the engine stalls about every 10-15 minutes but starts back up fine The engine stall at low speed and engine cut while shifting gear ,seen low pressure on the clutch

...stalling and rough run issue at low speeds This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor ...

...low sometimes stalls at stops Clean the throttle valve and the air bypass idle speed control valve, they get full of sludge and restrict air flow, this causes a low idle at times and the engine will ...

...EGR valve makes the most sense. It's famous for causing poor idling and/or stalling at low RPMS. Best of luck. Greg its the idle control.. just have it adjusted and everything should be OK after

...car starts jumping, if i have airconditioner on it gets worse and eventually stalls. what can it be. i have a 2003 chevy cavalier. SOUND LIKE ENGINE IS IDLING TOO LOW.HAVE IDLE SPEED CONTROL CHECKED. ...

...air control valve not working properly idle speed too low faulty transmission tcc solenoid both problems will set off check engine light.replace fuel filter and air filter,clean fuel

...stalling. This raises the idle speed a little bit. Mine was still too low so I took off the throttle body and noticed the idle adjusting screw had locktite on it. I heated it up with a propane torch ...