1986 Chevrolet S-10 Blazer "86 4x4" Questions

is an 86 transmission from a 2.8L the same as a is an 86 transmission from a 2.8L blazer 4x4.the same as a 1990 4.3L s10 blazer 4x4 ? no its not a match

...86 s10 blazer 4x4 2.8 I'm putting new timing gears and chain on my 86 s10 blazer 4x4 2.8. When I put the distributer in does the rotor button point to #1 plug at TDC. yes number on plug wire on the ...

i need to know what size wrench to use to tighten the flywheel bolts on my 86 s10 4x4 with a 2.8 most are 13 or 14 mm

...86 s-10 blazer behind an rv? It is a 4x4. Transfer case in Neutral transmission? Park or neutral running or not? help best solution is to remove the driveshaft to the rear, and disengage the front ...

86 s10 4x4 blazer wont start turns over fine.New fuel pump and filter new Ecm.When it cut off going down road it made a beeping sound from behind radio.Does ecm need to be reprogramed by dealer. No ...

86 chevy s10 blazer 4x4 2.8 I have a 1986 Chevy S-10 Blazer 4x4 2.8 and when I reach about 55 to 60 mph. the whole truck starts to shake bad. I replaced the u-joints and the passenger side front axle.

86 S-10 Blazer 4X4 auto trans 2.8 with AC. will not run now. changed fuel pump couple months ago ran fine till now. 34 code changed MAP sensor code cleared. found bad rotor changed rotor, Dist. cap. ...

...86 s10 4x4 blazer's with 2.8 engine. donor engine came out of a standard shift and mine is an automatic transmission.i've tried starter spacers, no help. I hope you still have the other starter .. If ...

...86 S-10 4x4 and the book said you need to remove the front and cab bolts and raise the body up a few inches to get enough clearance. Punched a hole through the firewall to get one of the engine to ...