1985 Chevrolet S-10 "replacing ignition control module chevy" Questions

Ad

Question about Chevrolet S 10

2 Answers

Ignition Control Module. If the Truck restarts after it has cooled off i would supect the Ignition Control Module, When the truck stalls have you check for spark and fuel when you crank it over a lack

Ad

Question about Chevrolet S 10

1 Answer

1996 Chevy S-10 4.3 Crank but no start Ive replaced fuel filter did a tune up replaced coil,ignition control module,crank sensor and still no start:( Are you getting any spark at any of the sparkplugs

Ad

...ignition control module located on top of the distributor (under the cap and rotor) I would pull the ICM and take it to NAPA and have it tested if bad replace it (cost about $80). Sounds like a ICM ...

ignition Control module,ignition key...and still no spark cranks fine just no fire? Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of

....changed fuel pump .filter .oil Chang air filter spark plugs every thing what do I do now it will only stay on for like a minute and it dies Replace the ignition control module in the

...ignition control module, rented a noid light system and there was no blinking from the noid light. Truck has plenty of pressure from the throttle body... truck will run just fine on starting fluid. ...

ignition control module, the little black box under the key switch, mine did this same thing and after replacing every fuse,relay and link, i tapped on the ign. module and everything turned on! tapped

Question about Chevrolet S 10

2 Answers

ignition control module). Its in the distributor. Remove the cap and rotor and you will see it. Its 2 inches long and 1 wide.There are 2 screws securing it, and 3 connectors attached to it. Remove the

Question about Chevrolet S 10

5 Answers

...ignition module with the key in the on position. I've checked all the under dash fuses and all are ok. Any ideas? Could it be the computer? Both fuses are good. Also the fuel pump is working and it ...

...ignition cycle. You only need to do a relearn if one of these are replaced Use this procedure after replacing: • Passlock™ Sensor • BCM • VCM • PCM Did you replace any of these ? 30 Minute Re-Learn ...

Not finding what you are looking for?
Cars & Trucks Logo

214 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...