1985 Chevrolet Camaro "iroc z28" Questions

IROC WITH A ZZ4 OUT OF A 91 Z28... fitted a 87 CHEVROLET CAMARO 5.7 IROC WITH A ZZ4 OUT OF A 91 Z28... fitted a ZZ4 motor from a 91 camaro into my 87 iroc, am using the 87 tpi system with accel intake

Need written instruction on installing an Ignition Switch on a 1987 Camaro Iroc Z28, can u help? go to mitchell1diy online and pay the ten bucks if noone responds..

...take a picture of the Diagram and send it to yea I have a 86 Iroc z28 So i have a Haynes manual for yours as well for most of the f body's are universal. I need a Email or a way to send you the

...iroc z28 had a 305 tune port in it now has a 350 carb need the wiring setup for this type of conversion WIRING FOR WHAT -THE PLUGS WIRING ARE THE SAME YOU NEED A MSD 6 AL BOX OR LIKE THAT FOR THE ...

...iroc z28 and cannot get at the two lower screws. Any ideas? You kn ow you have to take the outside chrome piece off, right? If you have the top screws out, you can usually just bend it forward enough ...

iroc z28 How do I replace the ignition switch on a 1987 z28 not the ignition cylinder where the key goes in. The ignition switch. seems alot of people are getting these confused. Do I need to drop the

iroc z28 i was on my way home and it started cutting off. i tried to start it but it wasn,t getting no gas. i change the fuel pump, and there is no power going to the fuel pump. i change the fuel pump

...Iroc Z28 5.0 engine. I'ts I have a 1987 Camaro Iroc Z28 5.0 engine. I'ts been running rough for awhile, wanted to die on me when I was stopped at red lights, I have been two footing it, just to keep ...

Z28 Camaro. Can anyone point me in the right direction? that depend on what harness you are looking for the ECUharness is located inside the car passenger side as you sit in the passenger seat it will

IROC Z28 Camaro HOW DO I REPLACE THE REAR AXCEL BEARINGS ON A 1988-Chevrolet-IROC-Z28-CAMARO Put car in neutral, remove wheels, calipers and rotors, diff. cover. rotate carrier until you see wrist pin