2006 Chevrolet Silverado 3500 "check class 2 serial data" Questions

...CLASS 2 DATA TO IPC. CHECKED ALL POWER, GROUNDS, SERIAL DATA, AND CLASS 2 COMMUNICATION AT IPC ELECTRICAL CONNECTOR, ALL IS OK. SUSPECT THE TROUBLE TO BE INTERNAL TO THE CLUSTER? its in your cluster, ...

...check the data pin? The protocol is VPW (Variable Pulse Width). Pin 2 is the data pin. Pin 4 is chassis ground. Pin 5 is signal ground. Pin 16 is positive battery. There are also pins in cavity 9 and ...

...check it . Complex electronics involved . If all the computers (control modules ) can't communicate the vehicle will not start .the radio is on that serial communication network . Other modules need ...

...check for DTCs. Class 2 serial data is transmitted on a single wire at an average of 10.4 kbps. This value is an average. Class 2 uses a variable pulse width modulation to carry data and depending on ...

...check for diagnostic trouble codes (DTCs). Class 2 serial data is transmitted on a single wire at an average of 10.4 kbps. This value is an average, class 2 uses a variable pulse width modulation to ...

...check it in the morning, and I believe if it is not the fuse, the OBD2 port was damaged and I will need to replace it. Still nothing on the trunk release button. What pins did your friend jump in the ...

...class 2 serial data circuit monitor for serial data communications during normal vehicle operation. Operating information and commands are exchanged among the modules. In addition to this, Node Alive ...

...Class 2 Serial Data circuit. To determine the correct power mode the PMM uses the following circuits: • Ignition 0 • Ignition 1 • Ignition 3 Discrete Ignition Signals Those modules that have discrete ...

...check for diagnostic trouble codes (DTCs). Class 2 serial data is transmitted on a single wire at an average of 10.4 kbps. This value is an average; class 2 uses a variable pulse width modulation to ...

...check for diagnostic trouble codes (DTCs). Class 2 serial data is transmitted on a single wire at an average of 10.4 kbps. This value is an average, class 2 uses a variable pulse width modulation to ...