2006 Chevrolet Silverado 1500 2WD "blowing hot air switch 2002" Questions

...hot air, could it be the compressor, shouldn't the compressor have a belt on it, and wher is it lovcated on the car your a/c should not blow cold air-- is the switched turned on inside your truck - ...

...blowing hot air so i turn the control the other way and eventually i get it to blow cold air if i want ac or hot air if i want heater, then if i hit a bump it will switch again, i have put up with ...

...blowing hot air, replaced low pressure switch Air only works for 20 min. Condenser clicks until blowing hot air. Replaced low pressure switch, still does not work. Can it be blend door actuator, or ...

...blowing hot air, cut the engine and start it again and blow cold air for a few minutes then start blowing hot air again. Just filled up the freon and the compressor deactivate about 5 minutes after ...

...blowing hot air but sometimes it works fine and blows cool. Is it a sensor problem? its probably the compressor cutoff switch cutting your compressor off at the wrong time and causing your ac to blow ...

...air. When you adjust the hot/cold mix switch you can feel changes in the air flow, but it's still cold air. Any thoughts would be greatly appreciated. Thanks. working on 4 and 5 speed that the ...

...blowing the hot air the light on the AC settings switch starts to blink orange. I'm not sure what the issue is here. Please help!! Thanks! Make sure your coolig fan(s) are running while the ac is ...

...blowing warm/hot air, then it started working again. Now both rear and front a/c blows warm/hot all the time. All speeds seem to be working in front and back. Doesn't change temp much by using ...

hot air. Today drove it home shut it off counted to 10 restarted car an This only happens when it is around 100 or above first make sure the cooling fan is turning on then flush out the condenser fins

...hot air heater core good,vacume lines good,switchs good Feel the heater hoses under the hood where they go thru the firewall. Both should be nice and hot if the heater core is allowing liquid to flow ...