2005 Chevrolet Trailblazer Ext "power steering pump" Questions

Power Steering Issues I have an 02 Trailblazer, when at idle or slowing for turns the trucks as though there is no power steering, after turning and accelerating the truck is fine. Is it the pump or ...

Power steering My power steering just went, fluid is full & my belt is not broken. No lights came on the dash at all. Please help!?!? The shaft inside the pump has broken. Know this for a fact! The ...

...power steering pump. Any thoughts. The power steering pump humms when it has gone bad. You need to replace or service it incase there is a blockage due to dirt in the transmission oil compartment. ...

power steering but if you raise the RPM's it's fine. Supposedly had a new pump installed to fix problem but didn't help. There is a sensor in the hydralic steering line that tells the PCM to raise the

power steering pump back in Jan. 2011. Just replaced it again b/c it was leaking from the shaft to the pump. Now only have power assist when the RPM's are higher...can you give me more information

...power steering pump but still makes noise, can anyone help check the idler/tensioner pully's and the alternator pully, there is a common problem with one of these 3 going bad, usually an idler pully ...

...power steering pump/steering rack. Runs great, shifts great, problem lessens after 30-40 minutes of driving but is still not as smooth as normal. Engine sometimes feels as if it wants to die while ...

...the fan, air conditioner, power steering pump, alternator etc. There is a pulley on it the maintains the tension. The is the idler pulley. They are plastic in most cases and wear out or

power steering water pump and belt most likely is an old belt because its stiff and slips when cold it warms up the belt is more flexible and it grabs beater the trencher can be weak and with the cold

...power steering pump if you are hearing it not moving or fan clutch I had the same problem and ened up replacing the alternator as the bearings were bad in it and the idler pulley had to be replaced ...