...serpentine belt first. this is done with a 15mm wrench put on the tensioner. then from the bottom you can get to the a/c belt tensioner. install a 3/8 ratchet on it and remove tension from belt. I ...
...it it replace a serpentine belt on a 93 chevy g20 van 4.3 hardest part is to remember how to rout the belt theres a place u can put a 1/2 inch or 3/8 ratchet on the tensior to make the belt slide ...
Question about Chevrolet Silverado 2500HD
...put on a serpentine belt of a chevy malibu.picture would help please. first of all,put a jack under engine, put wood on top to prevent from hurting engine,jack up till a little tension is on jack to ...
...put the ratchet head in the hole for the adjustment and swing it off to the side, and the belt slips right off, How To Install Replace Engine Serpentine Belt Tensioner Chevy Colorado 04-12 ...
Question about Chevrolet Silverado 2500HD
serpentine belt and belt tensioner on a 1997-2005 Chevy Malibu V6 3.1L.? Well you don't have to remove the tensioner. If you look at it, you'll see a 3/8 square hole in the arm of the tensioner. Put a
put belt back on? has to be an adjustment somewhere. The serpentine belt tensioner has a 3/8 drive rachet square on it. By attaching a 3/8 drive rachet and a strong forearm, pry the tensioner back and
Question about Chevrolet Silverado 2500HD
...serpentine belt. This is done by taking the tension off the belt. In order to do this take a 3/8 braker bar with a short piece of pipe and put in in the tensionser. Do not remove the bolt. The 3/8 ...
...serpentine belt on a 98 chevy malibu Its not that hard . Look at the idler pulley for the belt there is a squire slot troward the front in the middle of the pulley . A 3/8 ths . extentoin for a ...
Question about Chevrolet Silverado 2500HD
...put the new one on. I don't know to place it around the fan and fly weel If you have the Inline 6 (6 cylinder) ....watch the video below....it will have all of the info you need Hope this is helpful ...
...serpentine belt. 4. Loosen the tensioner bolt, and remove the old belt. You may have to raise the engine a bit to get a big enough gap to slide the belt through. 5. Put in the new belt and route it ...
1,273 questions posted
Usually answered in minutes!
241 Questions
48 Questions
21 Questions
5 Questions
4 Questions