2004 Chevrolet HD 6L VORTEC: Replaced the knock sensor and am in need of the TORQUE spec for tightening the new knock sensor... HELP?? Thanks! the torque spec is 15 ft lbs. hope this helps. Thanks Ray
Question about Cadillac Cars & Trucks
...knock sensor easy to change? no bypass to beat smog - emissions test didnt specify engine 4 8 5 3 6 0 knock sensor replacement GM Escalade 2004 knock sensor location and these links can assist in ...
Question about Chevrolet Silverado 2500HD
need to replace knock sensor/ O2 sensor 04 kia rio need to replace knock sensor/ O2 sensor, dont know location or degree of difficulty IT IS IN THE SIDE OF THE ENGINE BLOCK, SCREWED INTO THE WATER ...
...knock sensors are bad and need replacing. I am being told that the Knock sensors are not in '04 Durango's is that so? I would be surprised if it didn't. Try the following links, they will also show ...
Question about Cars & Trucks
...oil filter. There is only 1 knock sensor on the 3.4l engine. You need to drain the radiator to replace it. The 3.8l engine has 2 knock sensors.There are a lot of wrong answers on here so be
...This happens on engines that ave high mileage or acar that runs low grade like regular. probably need to replace knock sensor just because it is called a knock sensor it does not make the engone ...
...replace the sensor?? also i can seem to find any diagrams. any help appreciated!!! It does sound like the sensor may be bad, but you also need to check the wiring. This information comes from: ...
...engine soon light is on. weird noise (knock) on muffler. engine oil recently changed. need new engine sensor, perhaps and most likely you need to replace your "knock sensor" which is a very coslty ...
Question about Chevrolet Silverado 2500HD
need locations of knock sensors in 2004 3.2L vin L loss of speed , when downshifts speed picks up slower than before , slows on incline even with accelerator to floor. diagnostic says low fuel ...
Need to replace the knock sensors on a 2004 silerado hd with 6.0 v8, any special tools I need to change them out? I will also replace the manifold gasket a well nope can be done with a regular wrench,
1,273 questions posted
Usually answered in minutes!
241 Questions
48 Questions
21 Questions
5 Questions
4 Questions