Crank position sensor, where is the crank position sensor located, and how is it reached? Located near the crankshaft pulley usually. kia 2002 v6 2.7 no spark on no.1 and no4 have spark on 2&
Question about Chevrolet Silverado 2500HD
...at PCM No reference signal (crank-shaft position sensor) detected during engine cranking. Use this youtube step-by-step to fix it. How to diagnose P0320 crankshaft position sensor circuit ...
Question about Chevrolet Silverado 2500HD
...crank shaft: Crankshaft Position SensorOperationEngine speed is an important input to the Engine Management System (EMS). Crankshaft speed and position are the basis for many calculations made by the ...
...crank position sensor is mounted to the transmission bell housing at the left rear side of the engine block. Left is drivers side. If you have a 4.7 the crank position sensor is mounted into the ...
...crank position sensor is located to the back of the engine to the left of the oil filter, it is right next to the oil filter on the back side of the engine. hope this helps. Please rate my fix as i ...
...Crank Position Sensor they are obviously in 2 different spots, however they both either sit on the back of the engine or on the transmission bellhousing. Your Cam Sensor is at the top and your Crank ...
...from the camshaft position wheel. Possible Causes : PCM(power train control module), Mass Air Flow Sensor, Engine Coolant Temperature Sensor, Crank Shaft Position Sensor, Camshaft Position
...Position Sensor [A] circuit low input". This can be caused by a defective crank sensor, loose or corroded electrical connectors between the crank sensor and the PCM, defective PCM, or mechanical ...
...crank position sensor , the gear on the distributor or the timing chain. The quickest and cheapest check is the distributor gear which is what mine was. It's quite common. The gear is about $60 and ...
crank sensors have been replaced as well as synchronizer. Truck seems to run good. Thanks Harley. Did you reset the code after the replacement? Camshaft / Crankshaft Sensor is the reason for the code.
819 questions posted
Usually answered in minutes!
241 Questions
48 Questions
21 Questions
5 Questions
4 Questions