...oil do i put in compressor Your compressor should have 4 ounces of pag oil 150 in the compressor and 4 ounces of pag oil in the dryer or accumulator if its a 134 systerm. 8 ounces total. good
oil do I need for a 2002 chev hd 25000 4 wheeler with 4:10 gear ratio is it synthetic Yes you need full synthetic oil. It uses 75w-140 weight. About 3 to 3.5 quarts. Charlie The gear oil used is 75W90
...oil pump drive shaft retainer (4). During assembly, install a NEW oil pump driveshaft retainer. Refer to Oil Pump, Pump Screen and Deflector Installation. Install the engine oil pan. Refer to Oil Pan ...
...(just a caution to change your oil pump involves taking your oil pan off, if your truck is a 4 wheel drive you will have to drop your front drive assembly this job is not for the back yard
...4 times in 5 seconds. Hope this helps. Don G. What package do you have? If you have buttons on the steering wheel you can manually reset it by selecting the oil change reminder then holding down the ...
Question about Chevrolet Silverado 1500
...4 wheel drive. Oil level for 1998 truck The dip stick should be marked to show you what the level should be. Pull it out, wipe it off with a rag and put it back in and pull it out and take a look at ...
Question about Chevrolet Silverado 1500
oil pressure guage has been acting up 4 the past 2months. the other day i was driving on my way to the house and a light came up and said low oil pressure and myu truck turned off while turning off it
...oil What engine? General rule, have 6 quarts available. Put in 4 quarts, check level. If still low, add quart. Start engine, run for a minute. Stop, re-check oil level and fill to point on dipstick. ...
...4 days ,and today I noticed that the oil gauge is marking past 80 all the way to the right. It also is giving me a Change Oil Message . I need serious help don't know what to do? Check your ...
...4 wheel drive I get a squealing noise from the front end when I get it up to about 40 MPH. you need a might new hub internal bearing wiped out the seal goes and grease escapes and then bearing goes ...
1,733 questions posted
Usually answered in minutes!
4,236 Questions
159 Questions
130 Questions
67 Questions
56 Questions