...chevy blazer 4.3l engine Had a tune up around four months ago. Truck is misfiring and engine light on.... Start by checking each cylinder for spark with a good spark tester. A misifre is either spark ...
...if you remove it and carry it to them. P0300 Chevrolet Cylinder Misfire Detected Random Cylinders P0300 Misfire Detected Code Error code Random misfire on Chevy Blazer Changed distributor cap
Question about Chevrolet Blazer
89 chevy s10 misfires and sputters when i give it gas, dies when i stop. Sometimes it runs fine, but recently it's just been bad. When i rev the engine it can stabilize the idle, but usually die ...
...chevy blazer misfires when cold until the engines warm. changed the plugs, wires, cap, button, crank sensor, cam sensor, mass air flow sensor, fuel filter, air filter, and spark exciter. what ...
...Chevy Blazer, the check engine light (p0420 - catalyst efficiency below threshold) came on about 6 months ago. A mechanic told me not to worry about it. This morning the engine starting missing and a ...
...chevy blazer gets a po300 code and runs rough with no power. any suggestions? p0300 is an engine misfire detected p0301 would be misfire detected on #1 cylinder and so no throught p0306SOo seeing its ...
...misfire code on my 1998 Chevy Blazer. The code won't clear, and it runs erratic. i had same problem distributor gear becomes worn replace it and will most likely fix your problem they are known for ...
Question about Chevrolet Blazer
...misfire and the 02 should correct.We will start with the plug wire and make sure the firing order is correct 1996 chevy blazer that will make it a 4.3 engine size check the firing order firing order ...
...chevy blazer will idle rough. it gives me error codes, p0300 and p0135 and p0141. where do i find these problems Hello your po135 is o2 sensor bank 1 your po141 is O2 sensor bank 1 sensor 2 and your ...
...chevy blazer 4.3L v6. The check engine code was crankshaft sensor and cyl #2 misfire. If you have a distrubutor it is located in the side.Books says you have to turn the crank with a breaker bar to ...
1,772 questions posted
Usually answered in minutes!
2,307 Questions
1,793 Questions
1,647 Questions
1,619 Questions
1,503 Questions
