...98 chevy blazer. It used to only happen when i was backing up but now it happens when im driving forward too. I know its not the wheel bearings.it sounds like there's something loose. could anybody ...
...98 Windstar? YOU HAVE TO REPLACE WHOLE LOWER CONTROL ARM IF LOWER BALL JOINTS IS DEFECTIVE BECAUSE LOWER BALL JOINT IS SEALED AND IS A INTEGRAL PART OF THE LOWER CONTROL ARM BOTH IS COMBINED A ONE ...
...98-132 Nm). 10. Assemble the lower control arm ball joint stud to the steering knuckle, making sure the ball stud groove is positioned properly. Be very careful not to damage the lower control arm ...
Question about Pontiac Cars & Trucks
...98 transport. The lower ball joint is being stubborn. I tried ball joint remover tool and not much room to work with and still dont 98 pontiac transport/montana Lower Control Arm Print The lower ...
...98 regal, and I own the service manuals also. The lower control arm bushing that usually goes, is the front one. The rear one doesn't usually go, it is horizontally mounted. The front one for some ...
...lower control arm from the centerline of the control arm pivot shaft, dead level to the outer end of the control arm. Measure the distance between the lowest corner of the steering knuckle and the ...
...lower ball joints Yes it does have ball joints, and if I am not mistaken on a 98 model the ball joints are available without having to purchase the entire control arm, I think 99 and up you can not ...
Question about Cars & Trucks
...lower ball joint on an (all wheel drive ) Chevy , 98 astro van? It's a bolt in ball joint not a press in . Every thing I look up and find is on 2 wheel drive with press in joints , even got a hays ...
...lower ball joint on a 98 lexus gs400? you take of the tierod nut,the lower ball joint nut and unbolt the ball joint. you may have to use a puller for the tierod and ball joint pivet shaft.yhe upper ...
Question about Infiniti Cars & Trucks
...lower control arm on passenger side of my 98 infiniti i30 twice. Both times in a matter of a few miles went bad again front bushing seems to be loose and control arm shifts Have it checked by a front ...
1,772 questions posted
Usually answered in minutes!
2,307 Questions
1,793 Questions
1,647 Questions
1,619 Questions
1,503 Questions