...tail shaft is making this clicking noise while I have the rear end on jack stands and turning the drive shaft manually. Any thoughts? is that joint right there a U-joint or CV? Anywho check for ...
...in both cases . if 4wd drive try driving in 4wd using front wheel to drive vehicle , if it moves then rear diff or tail shaft is problem , if not gearbox is most likely dammaged hope this helps you
Question about Chevrolet Tahoe
...Is there a U-joint in the tail piece of a manual transmission ? There seems to be excess radial play in the front drive shaft spline. Normally there is a joint behind the transmission
Question about Cars & Trucks
drive shaft out of the tail shaft, transmission fluid will pour out of the tail shaft, so place a drip pan or oil-changing pan under the tail shaft of the transmission.Lines And LinkageIf the truck is
Question about Cars & Trucks
...tail shaft to find where metal shavings come from was convert now the gear at the end where the drive shaft goes is off so now wont go on how it get tlike this and how to fix the problem do I have to ...
...tail shaft housing on your transmition. That is towards the rear of the transmition near where the drive shaft enters the transmition. The sensor will have a 3 wire conector on it. It does not matter ...
drive then its the clutch driven plate is either worn out/or broken Input shaft, or tail shaft ????????????. Butif you got the rpms then the engine is fine and you dident need a fuel pump/or converter
tail shaft of the transmission. then you should be able to use a long exstension and a swivel to reach them. make sure you support the transmission after you lower it, so it wont fall on you!! 30" 1/2
...drive gears I was driving down the freeway cruised at 75mph and all of the sudden (No noise's) it went out of gear and reved up. Tried to manually Shift and it would not go into any gear. Park still ...
...arm is a steel shaft usaully mounted in a aluminum housing & the 2 unlike metals siez up & CORROID try using a good pennatrating oil on the shaft where the 2 shafts pass though the tail ...
1,468 questions posted
Usually answered in minutes!
904 Questions
942 Questions
830 Questions
647 Questions
668 Questions