2004 Chevrolet Impala "remove break front rotor" Questions

remove all rust from axle hub,caliper sliding& abutment surfaces,pads,both sides of rotors & protect thoseparts from further rust,your off to a bad start.That is not done professionallyYou can

...remove the lower balljiont nut, break balljiont free from spindle, pry lower control arm down and pull spindle to the side and pull axle out of spindle,next use a pry bar to pop axle shaft out of ...

...break free. If not, apply some heat to the seam area between the rotor and hub. It will smoke, but do not get it red hot. Remove the heat and try using the hammer once again. Be careful not to grab ...

...remove frount break rotors on 2004 Xterra 4wd Is there anything special that I need to know to remove and replace a set of frount break rotors on a 2004 Xterra 4wd? All you need to do is unbolt the ...

change front brake rotors on sebring 2001 jack front of car up, put on jack stands, remove tires, remove break calipers, remove caliper mounting bracket if nessisary, remove rotor.

...remove the front break rotors from my '02 mazda mpv. I have the break callipers off, there is a large center nut on the hub. should this nut be removed to get the rotors off? or does the rotor slide ...

replace front rotors and break pad removing rotor there is some kind of tool that they actually make to remove rotors that i purchased to get the rotors off of my '99

front breaks/ rotors in an 87 cougar and any other car? Autozone tells me the wheel bearing and hub assembly are all part of the rotor. Is this true? Is it any harder than changing breaks on any other

wheel studs that you can screw a bolt into to break them free. No you don't have to remove the axle nut. The rotor is just rusted to the hub. Whack it from the backside with a hammer. It will come off

...break free. If not, apply some heat to the seam area between the rotor and hub. It will smoke, but do not get it red hot. Remove the heat and try using the hammer once again. Be careful not to grab ...