my diesel is blowing unburned fuel and missing starts at 2100 rpm. also wont shift to drive or o drive is this related trans is bad and it sounds like you have a bad head or two
Question about Chevrolet 2500
I need a wiring diagram for the 4 wheel drive in a 1988chevy 2500 4 wheel drive Blow fuse when put in 4 wheel high Check for burnt or damaged sires going to the servo on the transfer case. It looks ...
check four wheel drive lghht comes on the push buttons for the four wheel drive the lights keep coming on and going off i was told by someone that it might be the push button switch i also bumped the ...
...you have to move the shifter back and forth to get it to catch. 1991 Chevy 2500 automatic 2 wheel drive, 350 motor, 2 wheel drive. Sounds like the shifter cable is stretched/bad. Not a hard fix ...
Question about Chevrolet 2500
...way its a 2500 If you look at the shaft where the gear is you may see a pin or notch. This is what drives the oil pump rod in the block. The distributor shaft and the oil pump drive have to match
...It's not load but it does clunk and you can definitely feel it. Any ideas? First verify that your drive shaft universal joints are not worn out. You can do this if you can raise the truck and place ...
I have an 2004 Chevy silverado 2500, 4 wheel drive, It goes from 2 hi, to 4 low, or sometimes will just say in neutral on the pushbutton, 4 wheel drive, lately the service 4 wheel drive comes on , do ...
...and engine sizes is there (4.3, 5.0 or 5.7) ? Keep in touch. trace the plug wire back from the drivers side front cylinder (for rear wheel drive) or the first cylinder from the belt side of the ...
recently had plugs,wires,and upper air intake leak fixed. truck still hesitates and bogs down from stop thru slow accelleration. mainly after a lot of stop and go driving. fine when at cruising speed,
256 questions posted
Usually answered in minutes!
89 Questions
84 Questions
92 Questions
60 Questions
53 Questions