1999 Chevrolet Blazer "dlc connector fuse car" Questions

...DLC connector where they plug their test equipment into. If you have a test light check for power and ground at the DLC Connector. If it doesn't have power then most likely you have a blown fuse. If ...

...DLC with a Volt Ohm meter and have no power to the connector. Any ideas? Jake Petersohn Check the fuse that powers the DLC. It might be shared with the cig lighter or aux power sockets adn may have ...

...DLC is located in the cab under the instrument panel on the driver's side. Turn ON the ignition, with the engine OFF. Observe the transfer case shift control switch select buttons for flashing codes. ...

...connector If the above circuits are normal but the TCCM still fails the Self-Test, replace the TCCM. Refer to Transfer Case Shift Control Module Replacement . DTC Displaying Turn OFF the ignition for ...

...dlc connector so scaner won't read codes Fuse #5 10A Data Link Connector (DLC) located in. Passenger compartment fuse panel The fuse panel is located on the left hand side of the instrument panel ...

DLC connector for B+ voltage . If no B+ voltage check to see if CIGAR fuse #13 20 amp is blown , location under hood fuse box . Do you know what the DLC connector is ? It's what you hook the scan tool

...for the DLC in a deville 2000 Typically the data link connector gets its power from the cigar fuse. On your vehicle there is a fuse in the underhood fuse block labeled ALDL (assembly line data

...DLC, and it says "operator error" (cannot communicate with computer). I checked all the fuses, and they're all good. Check terminal #16 (see diagram of connector) of the ...

DLC connector doesnt get any power when connected to a diagnostic tool check the fuses for the power outlet/cigarette lighter. The DLC usually gets its power from that fuse.

...is for cigarette lighter on toyota lucida It's the same fuse that powers the DLC (Data connector). Pop the cover top center of the dash board and check for power between pins 8 and 16 on the ...