1997 Chevrolet Tahoe "rivet gun" Questions

...rivet gun ,you will pay between $65-$100 for the rivet gun, if you have a friend at a local bodyshop i would borrow it with a deposit ,they get there gun back you get you cash back,hope this was ...

...do very slowly if spring comes out can hurt you very much once tension is released you can remove rivets holding in ball joint new one should just bolt in. to remove rivets the easiest way is a ...

...rivet gun you might be able to change it out (pry the old rivets out and attach the new wheel). Remember though that handyman guns are lightweight and the new rivets will probably not be as strong as ...

...also, when you go to rivet the handle back on, tape some cardboard under the handle. that way if the rivet gun drops after it snaps off the rivet, it will not scratch the door. hope this helps

...hold the regulator in place. You will need large rivet gun and some long reach rivets. The rivets are available from most parts stores (NAPA). Punch the center of the rivet out and remove the

...out and the either rivet the new motor in or bolt it the choice is yours, if you decide to rivet then Walmart carriers the rivet gun and rivets or any hardware/home improvement store. Good Luck ...

windowregulator replacement take off the door card in the door inside .may have been fitted with rivets if so you will need a rivet gun and some rivets.

...out of door there are 3 large rivets holding motor to the door they have to be drilled out to remove motor. To replace use 1/4 20 nut and bolt with lock washers. Or buy large rivet gun and

...a blind rivet through the new plastic rail and use the rivet gun to squeeze the rivet in place. Make sure it is the right length. get a grip gage and determine the right rivet for it. very easy

...I used bolts to put the motor back on the arm, but had to buy the big pop rivets and a big pop rivet gun to put the door back together.. All in all a big PIA.. I would take it to a shop..