1997 Chevrolet Monte Carlo "grip wont connect" Questions

wont take a jump. ok, get a set of jump cables... Next, ensure that they are correctly setup make sure you connect red-red first and the negative last! Get your friend to start up his car, tell him to

...grip handle with palm of hand in proper direction. This "impact" action will loosen terminal easier. Remember, vice grips are metal. keep away from positive side terminal when they are also touching ...

...rod is about to fall off. probably locked the gears inside the transmission. grab a pair of vise-grips and grab the connecting rod and try to move it that way and see if you get any

...grip slows down until traction is achieved,SO, if you accelerate really hard.and you get wheelspin,the car basically shuts down until you get full traction.feels funny but you wont get fined for tyre ...

...wont budge it has a rubber seal around it this seems to be stopping it from coming out also very little room to get my fat fingers in to get a decent grip pls help 1. disconnnect the connector. It ...

...also be the cause for the bad connection. The bolt may be tightened all the way, but it's still not gripping enough. If that's the cause, back the bolt out all the way. GENTLY, hammer the terminals ...

...wont start new ignition and door lock installed in 2007 honda accord Is the key and switch a matched pair? There is a chip in the key (black plastic grip). It must communicate with the switch for the ...

seems to try to start and then stop and just crank over and over again Could be one or more of many grips. 1. Fuel tank empty. 2. Battery discharged. 3. Battery terminal connections loose or corroded.

...wont start. when i turn the ignition it just makes a clicking sound sounds like that your battery connections might not be getting good contact, they may need cleaning, and make sure they are tight, ...

...wont start See if you can disconnect the fuel line on the fuel tank side of the fuel filter. Connect a rubber fuel hose to the line you just disconnected, and cycle the ignition switch (on and off) ...