...cam magnet is not really the problem, but the camshaft position sensor. This is what times your camshaft. It functions from a magnet. The replacement should come with everything you need . You may ...
Question about Chevrolet Monte Carlo
cam shaft and crank shaft position sensors. If they are good then it is most likely the engine control module. You check the sensors by ohming across the two wires that go to them. Also make sure they
...cam position sensor. Most likely a fault or bad sensor or bad sensor reading. One test was to clear it and see if it reappears. Because if it is an ongoing problem, it will trip it again. The check ...
...cam sensor when the car worked fine & the pattern is now not right,that is something for discussion. Some of those folks may be questionable ,but give them some credit for going to work in that ...
Question about Chevrolet Monte Carlo
...cam shaft position sensor. it is located on toof the engine toward the front of the vehicle. this sensor is bad, it will not allow the igniton coils to fire, giving you no spark at the spark plug. ...
...cam position sensor intermittent 0340 cam position sensor failure I would replace the cam position sensor from the codes you provided. The knock sensor would most likely be related to the sensor ...
Question about Chevrolet Monte Carlo
...cam position sensor I see Oil in the cam position sensor port Took the vehicle to auto zone and coded engine light, threw code P0011....cam position sensor. replaced cam position sensor, noticed some ...
...cam shaft position sensor? PCM= Powertrain Control Module. It is the brains of the car, it reads the sensor in put from all sensors including the cam shaft position sensor PCM , power control module, ...
...cam crank" sensor is the "reader" for position and speed of the camshaft. This sensor send informations to Engine Control Unit about camshaft position and speed. If the sensor is faulty engine stops! ...
...cam sensor OEM Japanese Denso, Made in China or Made in Mexico? Never go cheap on sensors. DTC P0348 stands for Camshaft Position Sensor "A" Circuit High Bank 2. This code triggers when the signal ...
583 questions posted
Usually answered in minutes!
605 Questions
554 Questions
577 Questions
528 Questions
359 Questions