1996 Chevrolet C1500 "chevy engine spider" Questions

chevy pu 305 vortec, had cyl 6 misfire and rough idle, replaced fuel injector spider now engine starts but idle real high then dies thats usually a sign of a vacuum leak, recheck and make sure you don

...engine was cranked. Could the whole injector (Spider) assembly be defective or should some of the injectors be spraying fuel. What should be the next step to diagnose the no start problem? Details As ...

...Chevy K-1500 wont start Engine cranks over, 60 + psi fuel pressure, and has great spark. One thing to check is fuel volume you can have press but not enough volume. also check for cranking vacuum you ...

chevy 1500 pickup 4.3L vortec.v6 .wont start on its own needs starting fluid when i get it to run have to constantly give it gas till it runs on its own. Heard it was an oil pressure sending unit that

engine running on 7 cyl. 1996 chevy 1500 pic-up 5.7V8 not fiering on #6cyl, Ive replaced plugs, wires, cap, rotor. Comp. on #6 is 215#. Any ideas? if you are getting a spark to the cylinder thats not ...

...chevy blazer has a spider CPI, or a multi port? A spider injector is located underneath the intake plenum and this is multi-port. Otherwise you have a throttle body injector system. Vortec engines ...

...chevy blazer will not start in the morning unless I prime the engine with a starter fluiid. Did a tune up and checked fuel pump. Once it starts it is ok for about 5 hours. Is there a senser which ...

...chevy suburban runs bad has new fuel pump, fuel filter,plugs wires cap rotor fuel regulator coolant temp sensor cleaned maf reman engine with 40k on it Check if the spiders are bad... I May be off a ...

...chevy vortec engine Just put chevy fuel pressure regulator & spyder assy in your search engine You willl have hours of reading etc Removing the intake will be a lot of work Installing the press ...

...chevy 6.0 vortec engine misfires on 1,5 and 6 when driving down the road. found this with the scanner hooked up and doing a live scan trying to trouble shoot the problem any ideas? Possible bad wires ...