1996 Chevrolet Blazer "engine revs accelerates slowly" Questions

down to about 1500 rpm. You do not want to over rev the engine. But holding it at about 1500 rpms for about 3-5 seconds will help flush out any excess fuel. You can then slowly return it to idle speed

...slowly put it in drive, OD, N,R,P and then shut it off, started it back up ...all was ok. till yesterday night...i was the RpMS stayed at constant 1000 in park..... ? and when accelerating..it would ...

...engine. First of all I had a new "black box" transmission installed last year because it was "slipping" bad. Anyways, when I crank it up, it idles fine and when I press the gas, it revs up fine. When ...

Engine revs with slow acceleration (manual trans) I have a 97 Cav z24 with 98,000 miles. It is a manual transmission. The engine revs up to near redline when in gear when I press the gas but the car ...

slowly begin to accelerate. Plus when in park, and trying to rev the engine it will miss like its trying to govern itself out. Sounds like emissions component problem. The cat converter may be plugged

...NEARLY STALLING THE ENGINE THEN SLOWLY GO BACK UP TO 900 RPM. SOMETIMES THEY DROP THAT LOW THAT IT STALLS THE ENGINE (NOT NICE GOING INTO ISLANDS) have the fault codes read and fix the faulty ...

revs even if I push the pedal to the floor there is no response, however after the engine has had time to warm up it slowly starts to rev up again and the vehicle is driveable but underpowered. Anyone

...revs the engine...and when im on flat ground going about 65mph in 5th gear when i go to accelerate it revs the engine but will not pick up speed as if it was not in gear. then when i let off the gas ...

...just the throttle sucking air when the engine is under a load. When you rev the engine in park it wont make the noise as much or at all. Try driving it and slowly apply the gas and see if it

...Engine revs normal until it reaches working temperature. when reach working temp. engine performance is a bit poor and it can?t reach max revs. it start to cut on 5400rpm in every gear, no matter how ...