1996 Chevrolet Blazer "chevy engine spider" Questions

...chevy blazer has a spider CPI, or a multi port? A spider injector is located underneath the intake plenum and this is multi-port. Otherwise you have a throttle body injector system. Vortec engines ...

...chevy blazer will not start in the morning unless I prime the engine with a starter fluiid. Did a tune up and checked fuel pump. Once it starts it is ok for about 5 hours. Is there a senser which ...

...Chevy blazer doesn't start well in cold weather. Engine will fire but kills shortly after it starts. Then it will crank over and over but usually won't start. If I leave it alone and try about a half ...

Chevy Blazer Engine Frozen One month ago I had the spider injector and upper plenum gasket replaced on my Chevy. It still never worked right after the repair. Highly noticeable vibration when stopped.

Chevy Blazer has a rough idle, has no power for sudden acceleration nor off startup. Also gets 6.2 mpg. The mechanic says it the spider injector? I need to get this resolved asap. It's a v-tech 4.3 v6

...Chevy Blazer 4.3 Vortech. The engine had been sputtering for a while when you pull out, but once you got up to speed it was better. Now, it will not start at all. Replaced the plugs, wires, coil, ...

...Chevy blazer...just bought a new fuel filter and ign coil...it cranks but won't start unless I use starter fluid...can u help? If you have the spider fuel system, I'd check that first. That system is ...

...chevy blazer engine runs rough at idle what do i need to do these were bad for the spider injectors to fail. they are hard to diagnose with out the scan tool. the poppets in the end of the injectors ...

...Chevy Blazer wont start after replacing heads. Now no fuel pressure. Need serious trouble shooting. Recently replaced spider fuel system. Make sure you have power to the fuel pump. On this model you ...

...chevy blazer will idle rough. it gives me error codes, p0300 and p0135 and p0141. where do i find these problems Hello your po135 is o2 sensor bank 1 your po141 is O2 sensor bank 1 sensor 2 and your ...