1996 Chevrolet Astro "high fan" Questions

...(behind the battery) was making intermittent contact, so the fan would not work on H. Connector was melted due to high current over so many years into fan. Replaced connector (dealer part) and

...fan only works on high when I turn on the fan it doesn't work in low or med settings but will work only in the high speed. Item that need to replace is the blower resistor. It is on the firewall

fan works on high but sometimes i have to hit it to start the fan. is this a fan is going or a restor. what do i need to change Fan has dead spots on commutator--replace fan

Where is the Fan motor relay on a 1995 chevy astro van with air Cond The fan works but not on high speed. I have replaced fan switch check the blower resistor near the blower motor,

...high. Other fan speeds work ok. what is the problem? It's a 2003 chevy astro van Hi, check fuse 12 first. If it is good, you will need to replace the blower resistor. The high speed relay is built ...

...high As for the fan your blower resistor is in need of replacement. To address the heat problem I'll need to know a couple of things 1. Does your vans temp gauge read in the normal range or is it ...

so the heater bit has gone If you do not hear the fan blower turn on when you turn the blower seting to low med or high then it is probably the resistors that control the fan speed that need replacing

...fan to run on lower speeds. This is bypassed on high (full speed 12 volts) and is not used. i would try to find its location. The possible locations are fuse panel under hood or dash and near the ...

If I jump Wires from battery the blower motor kicks on?? No power to it otherwise! The new resistor could be defective. Will the fan work on high speed ? Is fuse #12 in the instrument fuse panel good

...fan on the high setting. This happens all the time whether the AC is on or not. The problem is a 1/8 diameter hose that runs from the front of the engine over the top and connects at the rear of ...