1995 Chevrolet Monte Carlo "inlet hose leak" Questions

...hose inlet to fire wall. Any other suspects than heater core itself? Most likely a bad seal on the water pump. They will shrink up when it gets real cold out and leak. Look for a white line on the ...

...hose to the water inlet connection. Fill the engine with coolant, start the engine and check for leaks. Stop the engine and top off the coolant recovery reservoir as necessary. Good luck (remember to ...

...daughter said rps were high when just shut off Suspect an air leak on the inlet side off engine.check all inlet hoses and vacuum hoses.leak on dipstick and oil cap can cause a problem.good

...hose that goes to the brake booster from the inlet manifold. They tend to go hard and / or split where they connect to the metal piping if they are over 10 years old, allowing air / vacuum leaks into ...

...hose by the firewall is either your heater core inlet pipe or outlet pipe. These inlet and outlet pipes will develop leaks for a varity of reasons. If this is the source of your leak, you may want to ...

...inlet, and it leaks worse now. Check the hose sounds like a hair line crack in the hose. When working on these lines make sure everything is clean and tight when put together. The fluid is very thin ...

...inlet hose from the power brake booster. Disconnect the power steering cooler hose from the power steering pump. Disconnect the power steering pump remote reservoir hose from the power steering pump. ...

...hose to the water inlet connection. Fill the engine with coolant, start the engine and check for leaks. Stop the engine and top off the coolant recovery reservoir as necessary. Fig. Exploded view of ...

...hose connects to a plastic section that slots into the inlet manifold. This then relies on a rectangular shaped rubber gasket to seal against the engine block but can easily leak so a good idea is to ...

...inlet manifold on top of the engine can leak from its o ring seal where it bolts to the cyl, block. have a look if you can see coolant under the inlet manifold, you may have to remove the manifold to ...