Question about Cars & Trucks
...Chevy 4.3 new distributor cap rotors wires, plugs. Check timing multiple times top dead center good spark jumping an inch from the coil but I cannot get spark to my plugs I tried another distributor ...
Question about Chevrolet Astro
...Chevy vortex won't start, makes fast clicking noise by firewall on battery side Tried jumping, removed and reconnected battery terminals could be a stuck starter or solenoid, get a hammer and hit the ...
Question about Chevrolet Astro
...chevy cavalier Z24 car will stall at stop signs/ red lights and at times while I'm driving sometimes if I press the the gas pedal few times quickly i can get it to go but it jumps when it takes off ...
2 seconds then stopped again I have a 2003 Chevy Avalanche 1500 Z71 4X4. What you describe happened to me (6) times last week. #1, I replaced the ignition switch, $32.00. The issue happened again last
...2 time. I appreciate if you can help me. Thanks If you havent replaced the battery I would start there. If the battery has a dead cell in it then it will effectively remove the charge that your ...
...chevy truck 350 vortec number 1 plug wire should be pointing towards the front drivers corner . drivers side piston order is 1-3-5-7 front to back .passengers side front to back is 2-4-6-8 then the ...
...2 an hr or so, is usually the only way i can get it running! With the upper plenum removed and spark disabled turn on the key and allow the fuel pump to prime while watching the fuel lines from the ...
...chevy astro 2wd 4.3 L The van will start sometimes......other times it won't. When this problem first started I got it jumped and it started right up. Then I went to fuel the van stopped again and ...
Question about Cars & Trucks
...chevy cavalier. Battery is 2yo. Car will take a jump. Does not make any clicking noises, and lights,horn,radio work. Car would not start day 1,got jump ran fine,day 2 needed jump again, ran fine all ...
Question about Cars & Trucks
...chevy lumina 3.1L give no pressure readings on cylinders 4&6 and 220psi on cylinder 2 It's possible, But wouldn't have much pressure on #2. Most likely a blown gasket between #4 and #6. Pull both ...
367 questions posted
Usually answered in minutes!
481 Questions
367 Questions
305 Questions
235 Questions
248 Questions