1994 Chevrolet S-10 Blazer "vehicle barely starts putting gas" Questions

...barely goes anywhere. Its not the battery connections because I just took them off last night and cleaned them. Its not the alternator, i just put in a new one back in October and I also took it to ...

barely accelerates-check engine light on & leveling light on vehicle does not accelerate over 10-20 mph, you give it gas but it barely responds Catalytic convertor in the exhasut system is restricting

...vehicle speed and Manf. control. I changed the Spark Plugs and the Throttle Actuator Controller and it runs better but still sputters when I give it gas and barely moves. Your help would help me ...

barely move when you step on the gas. Sometimes it'll randomly start acting normal once the gauges start reading but if the truck starts without the gauge cluster from reading the truck it will run in

vehicle says : unknown driver, instead of Driver 1 or driver 2, you have had your battery totally dead. so dead that all the programming was lost, the part about not staying started, or not going into

...barely fills, it will not shut off. I've tried holding the rubber flange down but that doesn't help either. I've had it in the shop three times and they reset my check engine light but it comes right ...

barely runs and drives. Any tips on what I should do? Rather than to point out the obvious - you get what you pay for - let me try to help.  Vehicles in the scrap yard may sit there anywhere from

gas/fumes to cause an explosion in the few seconds it takes to perform the spark inspection. If you notice that the plug isn't sparking, make sure that you're grounded to the vehicle and try again. If

barely hold the clutch in and ease on the gas it will start to back up if i am on flat ground. a few people have told me that my synchronizer might be out but my other gears work just fine i just need

vehicle (works for older carburated vehicles) I'm assuming you are just barely putting pressure on the pedal. This may be as simple as an idle adjust at the throttle body or it may require programming