1994 Chevrolet Caprice Classic "loosen parking brake cable 1996" Questions

Parking brake doesn't work. The cable is adjusted so that it is tight when engaged. Follow the brake cable near the rear brakes and where the Y is loosen the locking nut and then unscrew the Y so that

Loosen the cable adjusting screw that is on the lever. Pull the lever all the way to its detent position which is Park. Release the parking brake and rock the vehicle to assure that it is in Park lock

loosen your parking brake. I believe it is just under the driver's seat but I 'm not 100% on that. Be careful not to over tighten it in fear of glazing you shoe brakes. Plenty of WD-40 to loosen it up

...parking brake cables completely. Follow the cable from one wheel to where it comes together with the cable from the other wheel. There should be an adjusting nut. Loosen the nut and turn the cable ...

...Loosen the equalizer nut. Disengage the front cable from the connector and equalizer. Remove the clip at the frame. Remove the cable from the hanger. Lower the vehicle. Fig. 1: The parking brake ...

parking brake today, but it got stuck at the top and the bottom won't come out. I removed the center console, but I can't find anything that will release it. Should I try loosening the nut at the base

...parking brake cable by loosening its adjusting nuts. Remove the backing plate plug, located on the back side of the backing plate. Insert a suitable tool into the plug until its tip contacts the shoe ...

...Loosen the neutral start switch bolt. Place the gearshift selector lever in the N position. Align the shaft groove of the switch with the neutral Basic line. Hold the switch in this position and ...

...parking brake, jack up car on front driver side. Remove Drivers side front wheel. Crawl under car by firewall. Look up on transmission (mid vehicle), you should see the bottom of the VSS as it screws ...

parking brake is on) and disconnect negative battery cable. 2. remove wheel on drivers side 3. remove caliper, bracket, and rotor 4. remove axle nut 5. unbolt tie rod end 6. unbolt lower ball joint 7.