1993 Chevrolet S-10 Blazer "egr valve bolts" Questions

...EGR Valve (exhaust gas recirculation valve). I am assuming that the engine in the vehicle is a 4.3L Possibly vortek engine. This is actually a common problem. More than likely you have a piece of ...

EGR valve its in front of and below the intake manifold a cylinder looking part connected to a small wiring harness. It is bolted on with 2 10mm bolts alot of times a piece of carbon will get stuck in

...EGR valve on 1994 Chevy S-10 4.3 vortec? The EGR Valve is right under the air intake hose, these have a habit of getting jammed by pieces of carbon. You can remove the valve by disconnecting the ...

were is the egr valve at on the motor its prob on the front of the intake up under the intake duct it has 2 bolts round about 4'' in length next to a/c compressor

need the gooseneck and thermostat....i need to know how to change them? You may need to remove the egr valve 1st.. then its 2 bolts for the neck or one may be a stud w/ 2 nuts .. hope this helps ;'';;

...and (2) Exhaust Gas Recirculation (EGR) Valve Fig. EVAP Purge valve solenoid (3) mounting bolt (2) and insulator (1) on 2000-2005 4.8L, 5.3L, 6.0L Engines Hope this help (remember rated the

...EGR valve. Remove the valve (2 10mm bolts hold it on. turn it over and you should see the pintle sticking out, push it in and out a couple times and clean it out with choke cleaner spray that should ...

...egr valve still runs ruogh sensor says piston miss fire, what should i change. ran great one day next morn ran rough as soon as turned on. Ok you have the most annoying problem there is with those ...

...that is rough i very seriously doubt it is your fuel system at all it most likely a bad egr valve especially with the aforementioned loping you described i cant believe that guy called himself a ...

...egr and engine no longer surges in drive. Sounds like e.g.r. valve is stuck and not fuctioning because of carbon build up, you will have to take off and clean, and clean inside intake where it bolts ...