1993 Chevrolet Lumina APV "install fuel pump" Questions

fuel tank. Install the fuel pump module into the fuel tank. Use the following procedure to install the fuel pump module retainer ring (except '02-'04). Fuel pump module installation Align the notch in

...Install the fuel pump tappet in the base of the fuel pump. Replace the O-ring on the fuel pump base. Install the fuel pump and bolt it in place. Install the fuel filter and connect the water drain ...

fuel pump. Install the rear seat. U must pull the fuel tank out, buy a service manual for further detail--read safety section first--make sure that the pump is the problem--cud be something else--view

...INSTALL FUEL PUMP ON 1989 CORVETTE how to install fuel pump on a 1989 corvette REMOVAL Relieve fuel system pressure. Disconnect battery ground cable. Remove fuel filler door. Remove fuel cap. Remove ...

...ring. Remove fuel pump. Remove and discard fuel pump O-ring. To Install: Install new fuel pump O-ring. Install fuel pump. Install fuel pump lock ring. Tighten to 66 ft-lb (89 Nm). Install Fuel

...fuel line. Install a new fuel pump strainer on the outer edge of the ferrule until fully seated. The strainer must be facing the same direction as it was before removal. Position a new O-ring on the ...

...fuel pump electrical connector. Install the trim panel. Install the spare tire and the trunk floor mat. Connect the negative battery cable. Start the engine; check the fuel system for leaks Road test ...

...ring. Remove fuel pump. Remove and discard fuel pump O-ring. To Install: Install new fuel pump O-ring. Install fuel pump. Install fuel pump lock ring. Tighten to 66 ft-lb (89 Nm). Install Fuel

...battery cable Fill the fuel tank with fuel. Install the fuel filler cap. Turn the ignition switch to the ON position to pressurize the system. Check the fuel system for leaks. Hope this

...fuel line(s) to the pump and install the line retaining clip(s). If equipped, attach the fuel pump electrical connection(s). Install access cover, then tighten the retainers. Attach the pump ...