1993 Chevrolet Lumina "crank sensor" Questions

...crank sensor located? I looked all around the harmonic balancer but could not see any thing? well you might want to replace the crank sensor on the car. those engines are known for bad crank

...crank sensor code i had a code pop up it was a generic code PO336 which is sensor a circuit or range problem i was told to replace sensor so i repaced the one behind the balancer and cleared code and ...

...crank sensor is located near the crankshaft of the engine, the shaft that rotates the pistons up and down inside the internal combustion engine. So look for wires that lead from the harness to this ...

...crank sensor or the timing, i don't know witch. Three things an engine needs to run, fuel, spark and compression. If you remove a plug wire, insert and screw driver ( don't damage the terminal in the ...

...Crank sensor or ignition module. You said the fuel pump works but have you checked the pressure? Have you checked it for spark? FIRST SCAN IT TO CHECK FOR FAULTY - PCM - CRANKSHAFT SENSOR - CAMSHAFT ...

1996 crank shaft postion sensor for a 3.0 lumina located where? CHEVY 3.1 ENGINE CRANK SHAFT SENSOR IS BEHIND CRANKSHAFT PULLEY.

CRANK SENSOR AND STILL WONT START.....WHY? If you changed the cranks sensor then what is needed for it to ever be able to run again is called a CASE learn.This a procedure that recalibrates the actual

...crank sensor on my 1992 chevy lumina the only problem is i cannot get the old crank sensor off AFTER SOAKING SEVERAL TIMES WITH A CAN OF "KNOCK IT LOOSE" or something better than WD, then Disconnect ...

...crank position sensor on a 1993 Chevrolet Lumina 3.1L? The sensor is actually plugged into the engine block and senses the crank position as one of the crank throws pass it. It is located on the rear ...

...crank sensor or ignition control module on a 96 lumina? we have a 96 Lumina, 3.1, that runs fine most of the time, but, sometimes idles rough and then wont start until it sits for about an hour. When ...