1993 Chevrolet C1500 "chevy hei spark" Questions

...Chevy 350 no spark I have changed the coil, cap, and rotor. Still no spark. I also changed the plugs and wires about 3 months ago Check the distributor module (ICM), it may have gone bad and needs to ...

...chevy 1500 4.3 no spark no fuel will spark at plug to motor when key turns off replaced oil sending unit oil sending unit connecter also fuel pump fuel pump relay plugs wires rotor cap and rotor bug ...

...Chevy Silverado 3/4 ton pick-up. It has no spark at the plugs. It turns over fine. I replaced the igniton coil and had the ignition module tested at Autozone. The cap, rotor and wires are fairly new. ...

chevy caprrice doesn't start. It was running fine at first. Whn I ook it in for an oil change, it just cut off on me on the way back and wouldn't startagain. Check spark. Is this one of those with the

Chevy Astro; power to distributor from the coil, but no power out the distributor. New rotar cap, magnetic switch and distributor and ignition control module, but still won't turn over. Help! check if

...chevy celebrity tec4 an have no fire from coil ive replaced coil checked fuses an have power going to coil still no fire i have replaced the ignition coil an all fuses are good an have power going to ...

chevy c10 350? These were still early times for the then new...HEI ignition...The factory was using a 60 mm gap...most mechanics used a 45 mm gap, as the 60 mm was proving to wide for peak performance

chevy van with an hei system Insert the number eight spark plug wire next and route it to the corresponding cylinder. For this example we use a Chevy small block firing order, which is: 1, 8, 4, 3, 6,

...Chevy S-10 Blazer stopped running while i was driving. That was 6 months ago and i still can't get it to run. I've replaced the battery, distributer cap, and the spark plugs and wires. The starter ...

...Chevy pickup CK 30I put a 400 in with the original transmission and swapped out the distributor and everything's been running nicely I just recently change my starter and Cap rotor plug everything in ...