1993 Chevrolet C1500 "chevy 350 engine start backfires" Questions

chevy Z71 pcm Mike i have a 1993 Z71 with a rebuilt 350 the problem that i have is that the truck died while driving it started to backfire when i would accelarate then the engine died no spark to the

...chevy 4/4 pu tbi 350 floods out I have a 1990 chey 1500 siverado 4/4 pu with TBI 350 engine. I caught wiring harness on fire as it backfired through the carb and caught on fire. I replaced all the ...

chevy truck 350 engine 93K miles when starting sometimes the engine will backfire..could be cold or hot engine..but after it runs for a couple of minutes will run fine.. A backfire usually indicates a

...chevy silverado 350 5.3 the engine will crank but won't start backfiring can be from incorrect firing order--- wires crossed , ignition timing incorrect or inlet valves remaining open--- hydraulic ...

...350 chevy silverado truck is backfires when i accerlate at 30 miles an hour starts to backfire i put a new ignition coil new vaccumm advance and still does the same thing. i checked the spark plugs ...

...chevy r30 with a 350 engine i just had the heads done. i got it together but it wont run right, teh engine turns over around 5-8 times till it fires, it idles ok, but when you try to rev it up it ...

...350 small block Chevy is the forward most cylinder on the drivers side of the engine. The cylinder behind #1 is the #3 cylinder the #5 and #7 on the drivers side. The #2 cylinder is the forward most ...

...Chevy K2500, 350 auto. The truck is hard to start but when it starts it idles smoothly. When I floor it, the engine stumbles a bit but immediately revs up strong. This is after the engine has warmed ...

...350 chevy firing order is 18436572. #5 & #7 are on the driver side, the closest to the back. #7 fires right after #5, by switching them I had caused #5 to fire too late / #7 too early hitting the ...

...chevy 350 1978 that runs but if you rev it a couple of times it will backfire through the carb and at an idle it pops out the exhaust.Could it be a couple teeth off on the timing chain? No. If you ...