...axle seals(rear)>> the bolt that you usualy have to take out is not there.. empty hole???? even if you could get the through pin to slide it can't go past the ring gear??????need help/ PINION ...
...axle shaft will cause the differential pinion gears to fall out of the assembly. This could result in chipped or damaged components. Remove the differential pinion shaft. Remove the differential ...
...axle housing. 2. Install pinion flange on pinion with reference mark aligned. Using appropriate pinion flange installer, install pinion flange on pinion. CAUTION: Washer must be installed on pinion ...
...axle shaft (4234) with the differential pinion shaft (4211) removed will cause the differential pinion gears (4215) to fall out of the assembly and damage the components. Remove the differential ...
...axle shaft will cause the differential pinion gears to fall out of the assembly. This could result in chipped or damaged components. Remove the differential pinion shaft. Remove the differential ...
Question about Chevrolet C1500
pinion mate shaft from differential case. Push axle shaft inward and remove axle shaft C-lock from the axle shaft. Remove axle shaft from side gear and axle tube. Remove axle shaft seal from axle tube
...axle tube. It may be stubborn at removal. If it is the pinion seal remove the drive line. Remove the pinion nut that rests inside the yoke. Try to use an impact tool for easy removal. Once the nut is ...
pinion seal leaking after making a 2000 mile trip pulling 11000lb.travel trailer I saw oil leaking from rear pinion seal.I can install the new seal but need toknow how tight to replace the pinion nut.
...pinion shaft out with help or yourself push an axle in from wheel side and remove c-clip slide axle out pry out old seal replace new slide axle in careful of seal replace c-clip do on other side ...
Question about Chevrolet C1500
...Axle Lubricant to differential pinion shaft lock pin . Install differential pinion shaft lock pin and tighten to 20-41 Nm (15-30 lb-ft). CAUTION: Differential pinion shaft lock pin must be tightened ...
404 questions posted
Usually answered in minutes!
584 Questions
420 Questions
403 Questions
331 Questions
284 Questions