1992 Chevrolet C1500 "drive shaft" Questions

...drive shaft i am changing the u joints on a 1997 c1500, and the center support bearing is trashed. i was wondering if there is a way to remove and replace this bearing without a hydraulic press The ...

drive transmission is the same everywhere except the output shaft is longer. can I exchange output shafts, and how big a job is it? If my memory serves me right, I'm pretty sure the only way to change

...drive from the shaft. To assemble: Lubricate the drive end of the armature shaft with silicone lubricant and then slide the starter drive onto the shaft with the pinion facing outward. Slide the ...

...to drive for any distance in 4 low. if your lucky. when your rearend went it didn't take out your drive shaft. if your not lucky. your drive shaft took some punishment and in turn damaged the

when pushing on gas pedal every 5 to 8 miles car vibrate until let up off gas pedal what kind of car or truck is this. i need to know but check motor and tranny mounts, axle shafts and drive shafts

...drive shaft if it clunks at all or has some up down or left right slop the joints are shot and will need replacing. And yes the u-joints will cause a drive line vibration that seems like a ...

drive shaft. Fluid is proper also. What you may be hearing is the wheel bearings instead of the transfer case. I had this problem with GM before and found it to be the wheel bearing was bad. I know it

1997 chev half ton wont start motor cut out while driving, did manager to start to get home with missing and banging when pressing gas. Next morning would not start or any attempt to pump has 60 ...

...drive shaft The rear end seal.first block the wheels,so truck does not roll away.remove drive shaft four bolts to do this.might have to a pry bar to seperate .then take a center punch and make a mark ...

there is a clicking sound up front when i'm in 4 wheel drive Several things it could be but the likliest answer would be drive shaft uni joint