1991 Chevrolet S-10 Blazer "chev map sensor" Questions

Can't find IAT, MAF or MAP on a 1993 Chev s10 4.3L, V6, w/carb? I have a TRC chip to install MAP SENSOR SHOULD BE LOCATED BY FIRE WALL UNDER THROTTLE BODY...

...Chev Blazer starts fine, idles fine, but won't rev above 2500 RPM, then when I take my foot off the throttle it sounds like it wants to stall but doesn't, it smooths out and idles fine again. How can ...

Chev. S-10 Blazer not idling. Have replaced cap & rotor, spark plugs and fuel filter. Any other suggestions would be appreciated. Thanks hey your oxygen sensor is probably bad Hi Riggsby! I assume you

...chev blazer 4x4 4.3 automatic.170000kms what is the problem?? Could be crank sensor, MAP sensor, Throttle Position Sensor, or the dreaded "Spider" injection system. Two more possibilities are Mass ...

chev pickup 4.3 that I asked you about a few days ago. I ran a ecm code reader test on my truck today and it gave me 2 possible fault codes, they were 3 flashes, pause then 2 flashes the other one was

...MAP sensor has been replaced. What else could it be? Sounds as if it is related to a Chev. This is usually caused by a correlation problem between the accelerator pedal sensor and the throttle plate ...

...chev S10 and its still doing the same thing it was doing before i replaced it. Is there something i may have missed or should have did when i put the new one on? MPS -- map sensor ? Manifold absolute ...

...chev 350 5.7 liter , my injectors will not work, there is fuel getting to the tbi, but somthing is telling them not to open, it was running bad now no fuel, i unpluged the map sensor. and esc. and a ...

where is the l map sensor 2005 chev cobalt It should be mounted on top of the intake manifold because it has to beable to read the engine vacuum..

Idles to high & will not change gears right. 1992 chev truck 150 idles to high and does not change gears out Clean the throttle body and map/maf sensor.