1991 Chevrolet Cavalier "starter dis" Questions

...gears done this mutiple times check timing, flywheel and replaced crankshaft sensor please help Some old gm cars use to have to have the staters shimmed because the starter drive woundnt dis ...

...starter go to power PCM or IGN, its tight to get to them but they feel ok. If you are getting the signal from the PCM to the DIS module, but the coils are not firing, that would be what I would look ...

...DIS-CONNECT THE BATTERY WHEN USING AN OHM METER.. Thanks Ray Almost every time a car is towed into my shop with this same story, it is being caused by bad battery connections. ALL of your battery ...

...starter Dis connect the battery, Locate it on the transmission, then dis connect the cables going to it, then loosen and take out the bolts holding it up. Piece of cake 1. Remove negative battery ...

...dis-connect the electrical connections from the starter making a note of where they are fastened, ( it's easy to get confused when re-assembling), now unbolt the starter. If there are any shims be ...

... i banged the starter and it dis-engaged, now i go to start it and just clicks, need boost to start, seems like starter is drawing power. Should i change the starter? yes solinoid in starter sounds ...

...it won't restart until after sitting for a while. Check for bad starter solenoid relay (next to the starter motor) and the POSITIVE + 12V connection. Look for and dis-coloration and clean the

spring loaded to engage, and dis-engage...this could be worn out and require a new starter...older cars sometimes used shims to set the necessary gap between the starter and flywheel...Hope this helps

...starter. Good luck, hope this helps. i think you should make a diagnostic, and i know a good tool named ...

...starter rngaged but did not dis engaged and burnt replaced with third starter now its doing the same starts but starter stays engaged any suggestions could it be the ignition switch? If that starter ...